- Stock: In Stock
- Model: ST22000978
- SKU: ST22000978
Specifications:
Item Name: WASP V2 2S Toothpick FPV Racing Drone
Wheelbase: 100mm
Size: 79x79x45mm
Weight: 35g(without battery)
Note: 360GO Camera is not included.
Motor | Motor Mode: GL0802 14000KV Configu-ration: 9N12P Stator Diamter: 8mm Stator Length: 2mm Shaft Diameter: Φ1mm Motor Dimension(Dia.*Len): Φ10.5mm*14.5mm Weight(g): 1.9g No.of Cells(Lipo): 1S-2S |
Flight Controller & 4 In 1 ESC | Flight Controller：Play F4 whoop Version: F411CEU6 MCU: STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board Size: 28.5 * 28.5mm Power Supply: 1-2S Battery Input (DC 3.2-8.4V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD (SPI Control) Built-in 5V 2A BEC Built-in Voltage Detection Firmware Version：Betaflight Configurator4.2.0 Onboard 4 In 1 ESC Onboard MCU upgraded to EFM8BB21 Power Supply: 1-2S LiPo/LiPo HV (3.5v/8.7v) Con. Current: 5A Peak Current: 7A (3 seconds) Support BLHeliSuite Programmable Factory Firmware: S_H_50_REV16_77.HEX Default Protocol: DSHOT300 Power Input: XT30 |
Frsky NON-EU/EU-LBT XM+ Receiver | Frsky NON-EU/EU-LBT XM+ receiver Version SBUS receiver Frsky D8/D16 switchable Compatible Non EU transmitter both D8 and D16 mode Channels: 8CH or 16CH Failsafe Support No Ground Interference ( Transmitter and receiver 1 m from the ground): 300m Operating Voltage Range: 3.7~10V Operating Current: 30mA @5V Operating Range: Full Range With RSSI Output on Board: Analog 0~3.3V Firmware upgrade-able, can be upgrade to EU-LBT with RSSI |
Frsky AC900 Receiver | Frsky AC900 receiver Version SBUS receiver Frsky D16 switchable Compatible Non EU transmitter both D16 mode Channels: 8CH or 16CH Failsafe Support No Ground Interference ( Transmitter and receiver 1 m from the ground): 300m |
| Frsky D8 Receiver | Frsky D8 receiver Version SBUS receiver Frsky D8 Compatible Non EU transmitter both D8 mode Channels: 8CH Failsafe Support No Ground Interference ( Transmitter and receiver 1 m from the ground): 200m |
| Flysky Receiver | Flysky receiver Version IBUS receiver Protocol: AFHDS-2A Channels: 14ch(AFHDS-2A) No Ground Interference ( Transmitter and receiver 1 m from the ground): 300m Failsafe Support |
| DSM2/DSMX Receiver | DSM2/DSMX receiver version Serial bus receiver Protocol: DSM2/DSMX Compatible Channels: 6-9CH (Depend on your radio) No Ground Interference ( Transmitter and receiver 1 m from the ground): 300m |
| TBS NANO Receiver | TBS NANO receiver version CRSF Protocol , Official TBS transmitter compatible Protocol: CRSF Channels: 8CH Failsafe Support No Ground Interference ( Transmitter and receiver 1 m from the ground): 500m |
| PNP | PNP receiver version Support any bus and other protocols, users can install by themselves |
| VTX | 5.8G VTX Power Switching: Third Gear(25MW 、 100MW 、200MW) Frequency: 40CH Input Voltage: 3.3V 5.5V Current Consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 Channels With Raceband Smartaudio Ready(Frsky EU-LBT and DSMX version not compatible) Weight: 2.0g |
| Camera | Camera GL950PRO: 1/4 COMS sensor Horizontal: 800TVL 800x600 TV System: Ntsc 4:3 non-changeable Power Input: DC 5-12V FOV: F1.2 Colorful: 0.1Lux(F1.2,50IRE,AGC ON) Black and White: 0.01Lux(F1.2,50IRE,AGC ON) Lens: m7 Signal to Noise Ratio: > 50dB Dynamic Range: >60dB White Balance: Auto White Balance Image: Color BLC: Stand By Video Format: NTSC Weight: 1.5g |
Propeller | Item Name: 65MM 1mm PC propeller Length/Inch: 65mm Pitch/Inch: 25mm Color: Red Material: PC Weight: 0.4/piece |
Recommended Battery (No Included)：
Species : Lipo/LipoHV
Capacity: 250mAh/300mAh/450mAh
Voltage: 3.8V
Continuous Discharge Rate: 30C
Instantaneous Discharge Rate: 60C
Connector: XT30
Features:
1. Use Play F4 flight controller to support 1-2s lithium battery power. Integrated Betaflight OSD function, display the flight voltage, receiver signal, and can observe the situation in real time during the flight.
2. Prepare Smartaudio, change the VTX frequency band and channel through OSD.
3. Adjust the settings and PID of the flight controller via OSD
4. 2S ultralight toothpick drone has strong power, low noise and long flight time.
5. Support Betaflight adjustment, multiple flight modes, carefully adjusted by the original factory, suitable for novice flight practice, stable style.
6. The nacelle cover is made of a one-piece injection molded plastic of a special material. Sturdy structure and light weight. It supports multiple camera adjustments. If there is enough space, the heat dissipation effect will be better.
7. The receiver version is used independently, and the electronic control is more stable. The flight control adopts the newer version of bf4.2, the ESC adopts version 16.77, the bidirectional DSHOT mode and the gyroscope RPM filter are turned on, making the flight control more stable
Using the latest GL0802 motor with a power input of 2S and a 65mm two-blade propeller, the efficiency is extremely high. Flight control is stable.
8. Double-sided RGB LED ready.
9. The thickness of the fuselage carbon plate material is 4mm, which will not deform or vibrate during high-speed flight.
10. The whole machine is controlled at about 35 g to achieve ultra-high and flexible control. Body weight becomes a professional indicator.
Package Included:
2 X 100mm Brushless Carbon Fiber Frame
2 X Plastic Cabin Cover
Option1: 1 X Play F4 FC external Frsky NON-EU xm+ receiver
Option2: 1 X Play F4 FC external Frsky EU-LBT xm+ receiver
Option3: 1 X Play F4 FC external Frsky AC900 NON-EU for Futaba receiver
Option4: 1 X Play F4 FC external Frsky D8 receiver
Option5: 1 X Play F4 FC external FLYSKY receiver
Option6: 1 X Play F4 FC external DSMX receiver
Option7: 1 X Play F4 FC external TBS NANO receiver
Option8: 1 X Play F4 FC PNP NO RX receiver
4 X GL0802 KV14000 Motor
1 X 65mm Propeller(4CW+4CCW)
1 X 5.8G VTX5840
1 X RGB LED
1 X Screwdriver Removal Tool
1 X Battery Installation Rubber Band
1 X Handbag
1 X Propeller Disassemble Tool
1 X Screwdriver
No Included Battery.
