702PCS Bagged Ceramic Tile Leveling Leveler T-shaped Adjuster Cross Paving and Wall Tile Positioning Tool
- Stock: In Stock
- Model: ST220015065
- SKU: ST220015065
$24.99
Ex Tax: $24.99
Feature:
● Abrasion resistant and recoverable.
● Easy to carry out DIY operation.
● Keep the tile balance in the same horizontal position.
● Improve tile installation speed.
● Reduce the fatigue/stress of the installer.
● Almost no lip slip, flat surface.
● Reduce the need for grinding and polishing.
● Prevent the tiles from moving during curing.
Use suggestions:
1. Lay the first tile, leaving a distance of more than 2mm (used with cross spacers). Close to the tiles.
2. Insert the T-shaped needle along the gap of the tile.
3. Then rotate 90° to clamp the T-shaped needle at the bottom of the two tiles.
4. Use your hand/special wrench to adjust the cover until both tiles are on the same level.
5. About 5-6 hours after leveling, before the cement/adhesive is completely dry, rotate the cap in the opposite direction and remove the 180° T-shaped needle until the words are taken out.
Package Included:
100 X Jorizontal Wedge Tile Gasket
2 X Wrench
600 X Cross
Tips:
1. The tile gap must be 2mm or more than 2mm (can be used with the complimentary cross card)
2. Leveling time one-clean up the cement or tile glue and other debris around the stainless steel
3. 4-6 hours after leveling,--before the cement or tile glue is dry, take out the leveler
Detail Pictures:
Notes:
1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
2. Please allow slight measuring deviation due to manual measurement.
Detail Pictures:
