Sensor & Detector Module

Feature:Range: 3TOverall accuracy:  0.03% F · SSensitivity: 2 ± 0.1 mV / VCreep: ± 0.05% F · S/30minNonlinear: ± 0.03% F · SHysteresis error: ± 0.03% F · SRepeatability error: ± 0.02% F · SZero temperature coefficient: ± 0.03% F · S/10Output temperature coefficient: ± 0.03% F · S/10Input impedance: ..

Feature: This load sensor, sometimes called a strain gauge, is the same one found in digital bathroom scales.The sensor is a group of a half-bridge strain gauge Ways to use it: Use one sensor with an external resistor to form a full-bridge measurement, the range of a sensor rang..

Features: 1.Using a five-way flame sensor design, the detection range is wide (the detection range of a common single flame sensor is about 30°, and the range is gradually reduced as the distance increases, the detection range of this product is greater than 120°)2.Can output digital signal..

5Pcs 6DOF MPU-6050 3 Axis Gyro Accelerometer Sensor Module ForDescription:Name: MPU-6050 module (three-axis gyroscope + triaxial accelerometer) 2.54mm pin spacing MPU-6050 Accelerometer + Gyro The MPU-6050 sensor contains a MEMS accelerometer and a MEMS gyro in a single chip. It is very accurat..

Feature: Active buzzer, no frequency signal, only need to offer signal to level can soundSuitable for button prompt, prompt warning and so on Specification: Size: 26 * 21mmVoltage: 5VPort: Digital levelPlatform: , microcontroller&..

Description:   This capacitive soil moisture sensor is distinguished from most resistive sensors on the market and uses capacitive sensing to detect soil moisture. The problem that the resistance sensor is easily corroded is avoided, and its working life is greatly extended.   The sensor has a b..

Specification:Wiichuck is a board for Wii-Nunchuck. Use this shield to achieve communication between nunchuck with for without broking the controller for Wii Nunchuck. It is grate for DIY projects. Dimensions: 1.02 in x 0.47 in x 0.28 in (2.6 cm x 1.2 cm x 0.7 cm)   Package includes:5 x Adapter ..

Features: PCB size: 1.5 x 1.9cm Working voltage: 5V Output high level when receive laser signal Output low level when not receive laser signal Note: The sensor uses a non-modulated laser receiver, please use indoors where no light, sunlight or other fixtures may interfere, recommended fo..

Package Included:5 x LilyPad TEMT6000 Light Sensor Module..

Description: Detecting temperature changes has never been easier. The MCP9700 is a small thermistor type temperature sensor. This sensor will output 0.5V at 0 degrees C, 0.75V at 25 C, and 10mV per degree C. Doing an analog to digital conversion on the signal line will allow you to establish t..

Introduction to RC522 chip:   MF RC522 is a high-integration read/write card chip used in 13.56MHz contactless communication.  It is a good choice for the development of smart meters and portable handheld devices.  The MF RC522 utilizes advanced modulation and demodulation concepts a..

Description:   1, Onboard TTP223 capacitive touch a single bond induction IC. 2, Board level indicator. 3, Working voltage: 2.0 V to 5.5 V. 4, The size of the PCB board: 29 (mm)x16 (mm).   Package included:   5 x TTP223 Capacitive Touch Switch Digital Touch Sensor Module..