Module Board

Feature:Camera: OV2640Camera Resolution: 2Megapixel Type: Normal / Lengthened Normal / Fisheye lens / Lengthened fisheye lens (Optional) Size: 21.77 x 12.61 x 4.28mm / 74.91 x 12.61 x 4.28mm Camera Seat: 8.54mm 24pin Array Size UXGA ..

Features:  Material: AcrylicColor: TransparentUse for: Raspberry Pi OV5647 camera / Raspberry Pi official camera  Type:  A: Only Bracket  B: Only Camera  C: Camera+Bracket  D: Camera+Bracket+ Zero Line Package Included:    1 x Acrylic Camera Bracket holder Kit..

Introduction: It is the original Raspberry Pi camera V2 version, 8 million pixels, compatible with any version of Raspberry Pi.  Note: Raspberry Pi Zero v1.3 Camera Cable needs to be purchased separately for Raspberry Pi Zero v1.3. Parameters:● 8,000,000 pixels● The photosensit..

Features:● Raspberry Pi Night Vision Camera, supports all revisions of the Pi● 5 megapixel OV5647 sensor● Adjustable focus distance● Camera specificationsCCD size : 1/4inchAperture (F) : 1.8Focal Length : 3.6mmAngle of View (diagonal) : 75 degreeSensor best resolution : 1080p● 4 screw holesUsed for ..

The touch dimming module can realize touch switch control and brightness adjustment of LED lights. It has the following features and advantages:⒈ The brightness of the light can be adjusted according to the needs, the selection range is wide, and the operation is simple and convenient.⒉ The touch fu..

Descriptions:This case is new fashion design for Raspberry Pi 2 Model B, transparent + black shell, five layer acrylic composition, simple and elegant, easy to install, all open interfaces, easy to use GPIO, TF card, USB and other interfaces,it use for raspberry Pi 3.2-inch, 3.5-inch screen and a ..

Descriptions:This case is new fashion design for Raspberry Pi 2 Model B, transparent + black shell, five layer acrylic composition, simple and elegant, easy to install, all open interfaces, easy to use GPIO, TF card, USB and other interfaces,it use for raspberry Pi 3.2-inch, 3.5-inch screen and a ..

Description:STAMP Cat-M is a compact global version of CatM & NB-IoT dual mode wireless communication module based on SIM7080G solution. The module adopts serial communication, Control Via AT Commands, and supports multiple communication protocols. It is designed for applications that need low laten..

Usage: 1. Connect to computer through emulator.2. Downloader Cable connects to the 10 Pin needle on Dongle.3. Supply power for Dongle through USB interface.The CC Debugger is a small programmer and debugger for the TI Low Power RF System-on-Chips. It can be used together with IAR Embe..

RF Parameter Value Remark Working frequency 861~876.5 MHz Default:  868MHz (24MHz oscillator) Transmitting power 4~14 dBm Default:  14dBm (About 25mW) Receiving sensitivity -108 dBm Air data rat..

Feature:1. Size: 4.1*1.6cm2. Board Thickness:1.6mm3. Operating Frequency:2.405-2.485GHz4. Wireless Transmission Speed Rate:250Kbaud5. Power Consumption:..

Specification:1. Product name: Zigbe Emulator Sniffer Downloader Module2. Supported software: SmartRF Studio, SmartRF Flash Programmer, IEEE Address Programmer, PacketSniffer, PurePathWireless, IAR for 8051 multiple versions (including 8.10 used by the new z-stack protocol stack), etc.3. Support ope..