Module Board

Description:This part can demonstrate three types of devices: solar windmill, solar lamp, and wind power. Use conductive tape to connect the circuit according to the schematic diagram of the circuit. It is not only easy to operate, but also helpful to deepen the understanding of the circuit.The sola..

Specifications: - Can be welding 18650/26650/32650 lipo battery, it is portable, stable and reliable- System voltage: 12V-14.6V- Working current: 90-150A - Suggested battery:1. 20-45ah Lead-acid battery with good performance and small internal resistance2. 3.5-5.5ah 45C 3S aerom..

Feature:Voltage supply: 9-12V DC Input Waveforms: Square, Sine & Triangle Impedance: 600 Ohm + 10% Frequency: 1Hz - 1MHz Frequency, amplitude adjustable Five-digit precision resolution It has coarse, fine frequency adjustment Wide range power supply, can use an external power supply 9..

Description:Model: DL10S (3.7V rated Li-ION Battery not for 3.2V Rated LiFePO4)common Version : common port for charge/discharge separate Version : separate port for charge/dischargeWe can customize any PCB from 1S to 30S lithium batteries with different current.(Quantity＞10)Highlight：For the same m..

>>>Manual: Contact Us<<< Friendly reminder: About using HomeKit: If you are an iOS system user, you can use HomeKit version products very conveniently. If you are an Android system user, the configuration of HomeKit functions is relatively tedious. For deta..

Description:This is Double socket dual base shield for D1 MiniPackage included:1 x Dual Base Shield 4 x Normal Pin..

Specification:Purely physical keyboard mechanical clicker, adjustable from 0.1 second to 999 seconds.Power supply: 12VType: DIY Kit/DIY Kit+adapter (option)Package included:1 x DIY Kit..

Description:DPS Series CNC relatively early NC products, software and hardware have been greatly improved.Operational aspects reserved V / A hot key, you can quickly set the voltage and current.Screen refresh rate also increased more than two times that is no sense of delay.Inc..

Introduction: The DS-CO2-20 is a digital CO2 concentration sensor based on the principle of non-dispersive infrared absorption. It continuously collects and calculates the concentration of carbon dioxide in air per unit volume and outputs it as a universal digital interface.The sensor can b..

DS18B20 Temperature Sensor Module Temperature Measurement Module Without Chip For DIY Electronic Kit for Arduino - products that work with official Arduino boardsIntroduction: Size:1.9x1.5cm(approx)Note: It is just a DS18B20 module shield, not include DS18B20 chip  ..

Product Description:Used on generators, DSR is suitable for all types of generators below 85KVA (single-phase or three-phase)●AVR: SX440, SX460, MX321, MX341, AS440, AS480, TC05AAVR: R230, R250, R438, R448, R449, R450, R450M, R450T, LSA432, R220●AVR, DVR2000E, SE350●AVR, AVC63-7F; AVC63-4, VR6AVR: M..

Features:1.Dual H-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motors 2.Built-in TSD, without worrying about motor stall 3.Ultra-small size, suitable for assembly and carSpecification:1.Module supply voltage: DC 2V-10V 2.Signal input voltage: DC 1.8-7V 3.Single wo..