Tyro129 280mm F4 OSD DIY 7 Inch FPV Racing Drone PNP w/ GPS Runcam Nano 2 FPV Camera
- Stock: In Stock
- Model: ST22000975
- Dimensions: 14.00mm x 14.00mm x 16.00mm
- SKU: ST22000975
$190.29
Ex Tax: $190.29
Notice:
1. Because the Caddx Turbo Eos2 Camera has been stopped produced, at present, this drone will replace it into Runcam Nano 2 NTSC 4:3 FPV Camera. ( April 14th, 2021)
2. replace new F4 flight controller, the same as Tyro99 and tyro109's flight controller.
| Old | New | |
| FPV Camera | Caddx Turbo Eos2 FPV Camera Case size: 19x19x16mm Weight: 5.5g Signal system: NTSC / PAL (Switchable) Resolution ratio(horizontal center): 1200TVL Video output Signal: cvbs Image: 16:9 Synchronization method: inter-sync Camera lens: standard 2.1mm Lens operating voltage: DC 4.5-40V S/N Ratio: >52dB (AGC OFF) Audio: YES | Runcam Nano 2 Image Sensor: 1/3" CMOS |
| Flight Controller | Eachine GPS F4 Flight Controller Main control chip: STM32F405 Gyroscope: MPU6000 Barometer: BMP280 Firmware: Support betaflight / INAV firmware Integrated OSD, support betaflight configuration & DMA Mode ( F4 MCU controls OSD) - Support PPM /DSM2/X / IBUS/ SBUS/ XBUS receiver - with 10V @ 1.2A BEC Output, for VTX or Camera | Same as Tyro99/ Tyro109 Flight Controller Item name: F4 flight controller Main control chip: STM32F405 Sensor: ICM20602 6-axis Power supply: 5V Integrated OSD PID cycle rate & gyro refresh rate up to 32Khz Supports BetaFlight / inva racing firmware (Link ) |
Specification: ( Manual)
Model: Tyro129
Item Name: 280mm F4 OSD DIY Version 7 Inch FPV Racing Drone
Version: PNP ( Without Receiver, Battery , Radio Transmitter)
| Item | Specification |
|
280mm Racing Frame Kit | Wheel base: 280mm
Frame arm thickness: 5mm
Upper plate thickness: 2mm Bottom Plate Thickness: 2mm
Side plate thickness: 1.5mm
Frame kit material: 3K carbon fiber |
| 2507 1800KV 3-6S Brushless Motor | KV: 1800KV
Lipo cell: 3-6S
Weight: 39g Motor Resistance: 0.0586Ω
Maximum pull: 1488g (4S 7inch propeller)
Maximum power: 840W
Configu-ration: 12N/14P Motor Stator Diameter: 25mm Motor Stator Thickness: 7mm Motor Diameter: 30.8mm Motor Length: 20mm Whole shaft length: 35mm
Mounting holes distance: 16*16mm
Mounting holes: φM3
Recommend propeller: 6-7 inch |
| Eachine 4In1 40A BLHeli_S ESC | Continuous current: 40A
Burst current: 45A (10S)
BEC output: 5V @ 2A
Input voltage: 2-6S
Main control chip: 48mhz EFM8BB2
Firmware upgrade: Supports Dshot150-600/Multishot/Oneshot/PWM MOS: 5X6 Current Sensor: NO
Size: 37.5x37.5mm Mounting Hole: 30.5x30.5mm Weight: 15g |
| Eachine GPS F4 Flight Controller | Model: GPS F4 Main control chip: STM32F405
Gyroscope: MPU6000 Barometer: BMP280 Firmware: Support betaflight / INAV firmware
Integrated OSD, support betaflight configuration & DMA Mode ( F4 MCU controls OSD)
- Support PPM /DSM2/X / IBUS/ SBUS/ XBUS receiver - with 10V @ 1.2A BEC Output, for VTX or Camera
- LED_STRIP solder pin, changing LED flashing mode & color via flight controller
- Buzzer solder pin, support connect external alarm buzzer
- with voltage detection port ( BAT) and current detection port ( CRT), to detect battery's voltage and current( Need connect extra current sensor module) - with MicroSD Blackbox Slot - with 5 UART & I2C Port, for connecting GPS Module - Plugs connector / Soldering Pads are Optional for all connector Port |
| Caddx.us Turbo f2 Camera | Case size: 19x19x16mm
Weight: 5.5g
Signal system: NTSC / PAL (Switchable)
Resolution ratio(horizontal center): 1200TVL
Video output Signal: cvbs Image: 16:9
Synchronization method: inter-sync
Camera lens: standard 2.1mm
Lens operating voltage: DC 4.5-40V S/N Ratio: >52dB (AGC OFF) Audio: YES |
| 5.8G 40CH 25/200/600mw switchable VTX |
Transmitting power:0/25/200/600mW switchable
Channel: 40CH
Full video format: NTSC/PAL
Input voltage: 7V~24V
Power dissipation: +12V@260mA/600MW Transmitting Distance: ≥0.5km@25mW, ≥1km@200mW, ≥2km@600mW
Size: 36×36×5mm
Weight: ≤7g (except antenna) |
| Eachine BN-220 GPS Module |
Model: BN-220 Item Name: BN-220 GPS+GLONASS Dual GPS module - Built-in FLASH, TTL Data Protocol: NMEA-0183 Output Rate: 9600bps, 1HZ Size: 22mm*20mm*6mm
1.TX LED:blue.The data output, TX LED flashing
2.PPS LED:red.PPS LED not bright when GPS not fixed, flashing when fixed |
|
DALProp & Racerstar T7056C 3-blade propeller | Model: CYCLONE T7056C Material: PC
Mounting hole: 5mm
Color: Transparent White + Transparent Blue Quantity: 4 pairs ( Per Color 2 Pairs ) Prop Spiral Diameter: 177.8mm Hub Thickness: 8.26mm
Weight: 7.5g/ PC |
| Recommend Lipo Battery ( NOT Included) | 5S 1600-2200mAh 50-85C Lipo Battery |
Package Included:
1x Tyro129 DIY Drone PNP
