- Stock: In Stock
- Model: ST22001229
- SKU: ST22001229
Notice: Have setting well out from factory, just bind and play.The orange raw materials are out of stock. Replace the orange remote control with white for shipment
DO NOT recommend change setting.
Specification:
Model: Tyro79S
Item Name: 140mm 3 Inch F4 FPV Racing Drone RTF
Version: RTF 2x Battery Version/ RTF 4x Battery Version ( Optional)
Receiver: Frsky XM+ Receiver
Flight Time: 4 mins ( Take example as 3s 650mAh Lipo)
| Tyro79 140mm Frame Kit | Model: Tyro79 Item Name: 140mm Wheelbase Racing Frame Arm Plate Thickness: 3mm Upper Plate Thickness: 1mm Side Plate Thickness: 1mm Material: 3K Carbon Fiber & CNC 6065 Aluminium |
| F4 OSD Flight Controller | Main Control Chip: STM32F411 Sensor: ICM20602 6-Axis Integrated OSD PPM/DSM/IBUS/UAR share: UART1-RX Mounting holes distance: 20x20mm Weight: 24g PID circulation rate and refresh rate can up to 32kHz Supports Betaflight/cleanflight/inav firmware |
| 20A BLheli_S 4In1 Brushless ESC | Continuous Current: 20A Burst Current: 25A (8S) BEC Output: NO Input voltage: 2-4S Main control chip: 48mhz EFM8BB2 - with 25V 150uF Capacitor ( Solder well on ESC Board) Firmware upgrade: Supports Dshot600/BLHeli_S/Oneshot125 MOS: 3*3 MOS Type: TPN2R703N Size: 27x31mm ( Mounting Hole: 20x20mm) Weight: 3.7g |
| 1607 2800KV 2-4S Brushless Motor | KV: 2800KV Lipo cell: 2-4S Weight: 17.8g (includes wires) Output shaft length: 14mm Maximum pull: signal 630g (4S 3030 4-blade propeller) Maximum power: 350W Configu-ration: 9N/12P Mounting holes distance: 12*12mm Mounting holes: φM2 Bearing: NSK N52 Strong NdFeB Magnet |
| SUNTHENTornado 3040 3-Blade Propeller | Model: Tornado 3040 Item Name: 3040 3x4 3 Inch 3-Blade Propeller Material: PC Mounting hole: 5mm Center thickness: 5.5mm Quantity: 4 CW & 4 CCW Color: Transparent White Weight: 1.8g/PC |
| XF5805 5.8G 40CH 25/100/200mW VTX | Supports TBS SmartAudio Transmitting power:25/100/200mW switchable Channel: 40CH Full video format: NTSC/PAL Input voltage: 7V~26V Power dissipation: +12V/200MW; 260mA Size: 25×20×4mm Weight: ≤3.2g (except antenna) With copper pipe mini antenna (ipex antenna) Make sure the antenna is installed at the output end before powering up to avoid damaging internal components |
| Eachine 700TVL CMOS Camera | Case size: 19x19mm Weight: 9.5g Total pixels: PAL: 1020H×596V (0.61MP); NTSC: 1020H×508V (0.52MP) Effective pixels: PAL: 976H×582V (0.57MP); NTSC: 976H×494V (0.48MP) Signal system: PAL Resolution ratio(horizontal center): 700TVL Video output: 1.0Vp-p/75Ω Automatic gain control: 0.25/0.50/0.75/1.00, up to 55dB White balance: off Exposure mode: electron exposure Electronic shutter: 1/50(1/60) - 1/100000 S Gamma correction: 0.45/1.0 Synchronization method: inter-sync Camera lens: standard 2.1mm Lens operating voltage: DC 5-12V Working current: 70mA (low power consumption) Working temperature: -20℃~-60℃ Humidity: 0%~98% |
| Frsky XM+ Receiver | Number of Channels: Up to 16CH from SBUS (1-15ch for PWM,16ch RSSI for FC) Operating Voltage Range: 3.7~10V Operating Current: 30mA @5V Operating Range: Full range With RSSI output on board: Analog 0~3.3V Firmware Upgradeable Compatibility: FrSky D16 mode Dimension: 21.5*12*3.5mm(L x W x H) Weight: 1.6g |
| LiteRadio Radio Transmitter | Model: LiteRadio Version: Mode 2 Frequency Range: 2.4G (2403MHz-2447MHz) 2.4G System: CC2500 Channel: 8 System: Frsky Protocol (D16/D8) Power: ≤80mw Model Type: Multi-rotor Support USB Charging Support FPV Simulator Connected Output: PPM, support Student Radio Mode LED Light: Green-Power On / Red-Warning / Blue-Normal Battery: 350mAh 2S Lipo Battery Weight: 227.4g (with battery) |
| 3S 11.1V 650mAh Lipo Battery | Item Name: 3S 11.1V 650mAh 45C 3S1P Lipo Battery XT30 Plug Size: 57x32x19mm (LxWxH) Weight: 55g |
Features:
- The drone builds and setup well out from factory
- with Battery, Receiver and Radio Transmitter, ready to fly
- Upgrade with TPU Part on the tail, more easier to install receiver cable and antena
- Upgrade with Racerstar Tornado 3040 3-Blade Propeller, more power and durable
Package Included:
2 Battery Version:
1x Tyro79S FPV Racing Drone
1x LiteRadio Radio Transmitter ( Mode 2 version)
2x Eachine 3S 11.1V 650mAh 45C Lipo Battery
1x 350mAh 2S Lipo Battery ( for Radio Transmitter)
1x B3 Pro Charger
4 Battery Version:
1x Tyro79S FPV Racing Drone
1x LiteRadio Radio Transmitter ( Mode 2 version)
4x Eachine 3S 11.1V 650mAh 45C Lipo Battery
1x 350mAh 2S Lipo Battery ( for Radio Transmitter)
1x B3 Pro Charger
