Search

Features: This board is the simplest way to create a project with multiple capacitive touch sensors.No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins.When a capacitive load is detected (e.g. a person touches on..

Specification: Model: VOC Gas Sensor - AGS01DB Measurement objects: ethanol, ammonia, sulfide, benzene vapor, smoke, polluted gas, harmful gas, volatile organic compounds, etc. Size: 16*12.5*5.8 (mm) Supply Voltage: 3.3-5.5V DC Mini supply current: 24mA Maximum supply current: 30mA Typical power sup..

Features: This board is the simplest way to create a project with multiple capacitive touch sensors.No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins.When a capacitive load is detected (e.g. a person touches on..

Introduction: The DS-CO2-20 is a digital CO2 concentration sensor based on the principle of non-dispersive infrared absorption. It continuously collects and calculates the concentration of carbon dioxide in air per unit volume and outputs it as a universal digital interface.The sensor can b..

Note:  When you receive this sensor, the surface is covered with a blue protective film. When you peel off the film, you can see the stainless steel case.   Working principle:   This sensor uses the principle of light scattering. That is, the illuminates the suspended particles ..

Description:The performance of this module is stable and precise measure of distance. And comparable foreign SRF05, SRF02 Ultrasonic Ranging Module. Module precision, blind spots (2cm) super close, stable distance measurement is strong based on this product successfully to market! This module is com..

>>>Manual: Contact Us<<<Specification:Product model: HW-XC901Working voltage: 6-24V (Built-in 7550, need constant power supply, minimum drive 6V300mA ± 100mV)Static power consumption: <15mAOutput mode: 3. 3/0V, 3.3V with induction, 0V without induction (the output voltage c..

Features: - Single channel signal output- Low level output signal used for human body touch sensor alarm- Adjustable sensitivity- With fixed bolt hole for easy installation Specifications: Working voltage: for DC 5VMaterial: PCB + BrassDimensions: 43 x 16 x 1..

Product Specifications:Product Name: Soil Moisture SensorSize: 36×15×7mmVoltage: 3.3 -12VDCCurrent:Working..

Features :   - Sensitive material MQ-6 gas sensor is used to clean the air in the lower conductivity of tin dioxide (SnO2). When there is the environment in which the combustible gas sensor , conductivity sensor with increasing concentration of combustible gases in air increases . ..

Features :   - MQ-8 gas sensor sensitive material used in clean air conductivity is lower tin dioxide (SnO2). When the sensor is present in the environment in which the combustible gas, the sensor's conductivity increases with the concentration of combustible gases in air increases. ..

>>>Manual: Contact Us<<<Feature: Product number ZE08-CH2O Gas detection formaldehyde Interference gas Alcohol, carbon monoxide, etc. Output Data ..